PSU MKS Bracket

Its a bracket to attach an MKS board to the top shell screws of a salvaged dell PSU. Holes are proprietary I think. Front reference is with AC-In on left, wire harness and fan on right. Relative to this, the bracket mounts to the top, intended to be turned on its side (Top facing you). Hole offsets to center (for checking compatibility):

Left 13mm inset, 5mm from side
Right: 20mm inset bottom 17mm inset top, 5mm from side.

If these line up, it should fit

Added feature:
Holes in main bracket for orange pi (or any similar layout board). there is no room for nuts behind so its probably best to use a case. I used this one:
https://www.thingiverse.com/thing:1583252
With 20mm m3 bolts and nuts, the extra screw overhang fits perfectly and keeps it in place.

Added feature: air curtain for cooling with 80mm fan. This initially had parts to clamp the thin supports, but after using it they are not needed. I have removed them.