Thingiverse
PSVR hook for hanging the headset
by blueagle
34
Downloads
25
Likes
1
Makes
The PSVR headset was laying on the floor so I thought of 3d printing a hook that could be attached to the IKEA furniture.
I did not want to use screws, so I created it large enough to support the headset.
remember to use silicon, is very strong (it is used in aquariums) and it doesn't leave anything back if you decide to take it off.
In the pictures you can see the "attachment phase" and the final result.
use infill 20% minimum, I suggest gyroid, it makes it strong in any direction.
as usual enjoy ;)
I did not want to use screws, so I created it large enough to support the headset.
remember to use silicon, is very strong (it is used in aquariums) and it doesn't leave anything back if you decide to take it off.
In the pictures you can see the "attachment phase" and the final result.
use infill 20% minimum, I suggest gyroid, it makes it strong in any direction.
as usual enjoy ;)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
