PTT Hand Switch

Designed this hand held push-to-talk (PTT) switch. It is useful when standing or other cases when a foot switch is not practical, or when contesting and someone else is logging for you.

Print the button with a different color than the top and bottom pieces.
Supports are needed for the button opening, but not necessary for the rest.
Should be obvious, but be sure to rotate the parts with the largest face down. I could not figure out how to get Fusion360 to do this.

The Tester is not required, but can be used to see if your print settings are good with the tolerances without having to print the entire case. This was my first design using Fusion360 and I went through a lot of iterations to get the tolerances right to give the button a nice feel.