PTZOptics Camera Wall Mount

A wall mount for the PTZOptics line of pan tilt zoom cameras. This was designed for the 30X SDI camera but should work with the entire product line.

The camera itself is rather large but this mount is designed to accommodate it while fitting the build area of my printer (200x200x180mm).

As shown in the top down photo, I use an L shaped BNC connector for the SDI port to allow the camera to be positioned closer to the wall. You will also notice below that I printed this with a 20% infill. I am confident that the final print is more than sturdy enough but feel free to increase the infill if it makes you more comfortable.

I also did not use any supports but you may want to if your printer doesn't do a good job spanning the side cable ports.

While the camera would probably stay in place just fine by itself, I secure it in place with this screw:

https://www.thingiverse.com/thing:4003381