Thingiverse
puck holder
von omurina3d
1
Downloads
1
Likes
0
Makes
This is my first creation on Thingiverse so I hope you like it.
I used onshape for modeling. And a Prusa slicer for slicing. In the slicer, I rotated it by 4.5 degrees. I used less than 10 meters of filament and printed it around 11h.
You can even sell the model if you say it's from me :)
I used onshape for modeling. And a Prusa slicer for slicing. In the slicer, I rotated it by 4.5 degrees. I used less than 10 meters of filament and printed it around 11h.
You can even sell the model if you say it's from me :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!