Thingiverse
Pull out the Fuse
von martin_11
3
Downloads
4
Likes
1
Makes
Mithilfe des Bauteils kann man kleine Sicherungen 6 x 30 mm bzw. 5 x 20 mm leicht aus den Fassungen von Platine ziehen. Gedruckt mit PLA auf einem Ender 3D Pro
With the help of the component, small fuses 6 x 30 mm or 5 x 20 mm can easily be pulled out of the sockets on the circuit board. Printed with on an Ender 3D Pro
With the help of the component, small fuses 6 x 30 mm or 5 x 20 mm can easily be pulled out of the sockets on the circuit board. Printed with on an Ender 3D Pro
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!