Thingiverse
Hobby
Zum Modell
Pull-Relief for 6 mm Cable
628
Downloads
533
Likes
0
Makes
This pull relief is made for 6 mm cables (antenna cable in my case).
Print it with 0.1 mm layer height and everything should work fine.
bruncedric relesed thing:5262888, which is very similar. His "cable screw conector" is for a greater variety of cables. Check it out!
I needed it a lot smaller and as bruncedric didn´t allow derivates, I had to draw everything from scratch. I will use two of mine to build an 1800 Mhz-LTE-Antenna.
Use Freecad to modify/remix it.
Print it with 0.1 mm layer height and everything should work fine.
bruncedric relesed thing:5262888, which is very similar. His "cable screw conector" is for a greater variety of cables. Check it out!
I needed it a lot smaller and as bruncedric didn´t allow derivates, I had to draw everything from scratch. I will use two of mine to build an 1800 Mhz-LTE-Antenna.
Use Freecad to modify/remix it.
willie42 veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
