Pull Start Cord Handle

This is a pull start handle I made for my snowblower that is large enough to use 4 fingers for pulling. It can work for other pull start equipment like lawn mowers, power washers, etc. It has a 0.15" hole for the pull cord and space for the knot to fit inside the handle. It also has a tapered tip with a 0.5" diameter to fit into the cup on the engine or on an eyehook that is sometimes used on the equipment handle to bring the pull handle closer to the user. It can easily print flat with minimal support to the build plate only, leaving out support for the cord hole. I printed with 100% infill to make the part as strong as it can be. I used PETG but PLA should work just fine.