Pullip Doll Face Plate 3D printable

Pullip Face Plate 3D printable info.

The face plate was created from a 3D scan of a Pullip head from a mark 4 body the most recent and most produced / released body. Then altered with fill on the inside to thicken it so it can be printed. Anyway it has then been sized up about %5 to %8 so it fits over the face nicely. So print it this size and see how it fits your Pullip then reduce or enlarge etc if needed. If your looking to replace a Pullip face well this probably wont work, no bits inside to locate eye mech etc, but you could use it to practice faceups, reduce it %5 or so to get it back to original size if needed. There is a shorter plate in here which is just the full face one cut down so it fits on as shown in the picture and stays under the hairline. Also the lower jaw insert and correct size in the file names means it fits over an original face as is and will go over the jay and there is a cutout so it goes past the neck. So many file prints and alterations to get to