Thingiverse
pully one piece
di skymeowo7
29
Download
17
Likes
0
Makes
simple one print pully for cables small loads or ceiling run VR cables.
it requires abit of finagling and abit of cutting the points that slide together, but once together feed your cables or rope through (or do it before in some cases) place the wheel thing inside the hole, then at a slight hard angle press and pull it together
i may update this in the future but so far it works perfectly for what i need
I HIGHLY RECOMEND use the cura program and use tree supports
it requires abit of finagling and abit of cutting the points that slide together, but once together feed your cables or rope through (or do it before in some cases) place the wheel thing inside the hole, then at a slight hard angle press and pull it together
i may update this in the future but so far it works perfectly for what i need
I HIGHLY RECOMEND use the cura program and use tree supports
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
