Pump Aid - GamoP900

####Pump Aid for Gamo-P900

If you have one, you know the front sight is a killer on the palm of your hand. This takes care of that in addition to increasing the leverage for pumping.

Just slip it onto the gun all the way so the inner-boss sits inside the front-sight. Pump gun and remove the aid...

Some folks have difficulty printing Radius’ on bottoms and overhangs, this part has mostly Chamfers with small radius for edge smoothing.

####Print Tips:
Bottom Layer = 3
Top Layer = 3
Shells = 3
Infill pattern: Cross-hatch (depends on your printer/software - photo shows settings for Simplify3D to accomplish cross-hatching)
Print Height = 0.3mm or less (saves time Vs 0.2)

You shouldn’t need supports for the short ‘straight’ overhang-area if your process is dialed in (a Temp of 230C will enable bonding of strands and produce a nice part). See photo.

Sand/smooth the Ejection Mark-Flashing marks on you gun if they interfere.