Thingiverse
Pump for 130 motor
by spen15
11
Downloads
9
Likes
0
Makes
This is a bilge pump I made for my RC boat that uses a 130 size motor, I also use it for water cooling in the boat.
You may need to drill out the holes a little bit, and I just glued the motor to the housing but you could make holes for screws.
Motor I used: https://www.amazon.com/Tamiya-Low-RPM-Type-Motor/dp/B005AFBLIA
The two bladed impeller works much better BTW but the 3 bladed handles debris better.
You may need to drill out the holes a little bit, and I just glued the motor to the housing but you could make holes for screws.
Motor I used: https://www.amazon.com/Tamiya-Low-RPM-Type-Motor/dp/B005AFBLIA
The two bladed impeller works much better BTW but the 3 bladed handles debris better.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!