Thingiverse
Pumphouse
von 3Dresearcher
2
Downloads
2
Likes
0
Makes
A housing for the kidwinds water pump. By doing this the inlet is always at the bottom of the recipient. By doing this the pump can drain the recipient better.
you need 1x house and 2x the lid. There is a margin between the lids for the cable of the pump.
designed for use with this pump : https://www.vernier.com/products/kidwind/power-measurement/kw-pump/
you need 1x house and 2x the lid. There is a margin between the lids for the cable of the pump.
designed for use with this pump : https://www.vernier.com/products/kidwind/power-measurement/kw-pump/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!