Pumpkin Bucket

A halloween without candy is a trick! Do not go outside without this cube with flashing lights.

This is an easy impression but it is large. It measures approximately 120 mm round and 80 mm high. No supports required. Printed at 0.2.

The pieces fit perfectly, it is not necessary to use glue. For the handle you can use a wool yarn. Insert the thread through the holes and tie a knot.

You can use the pumpkin bucket without lights. Although, if you want to add the lights, see the following information.

Blinking lights
============

You need:
- 1x Arduino nano
- 5x Yellow LEDs
- 5x 220 Ohm resistors
- 1x 9v Battery
- 1x 9v Battery adapter
- Wires


Schematics
---------------


Assembly
-------------

Step 1:
Solder the LEDs with the resistors

Step 2:
Solder the cables following the schema.