Thingiverse
Pumpkin cookie
von lmic
8
Downloads
6
Likes
0
Makes
I designed this pumpkin cookie cutter. The inner part must be print at 98% to slide in the outside (but it works also at 100% without sliding). I used PETG 80/230.
If you are going to download and print, just share a picture of the print or of the cookie !
If you are going to download and print, just share a picture of the print or of the cookie !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!