pumpkin happy halloween

Hello. This is my first project here.
I invite you to use.
I prepared several versions, the inscription itself.
Plate with the inscription without holes. Plate with inscription and holes.
Plate and inscription with different font type.
in the plate with the inscription without holes, remove the lower and upper layer. Apply a 20% fill. pattern fill lines. A nice checkered grid will be created.
The plate is 2mm high. the inscription is 3mm high.
If you want to print in two colors, use an additional peg to change the filament on it so as not to damage the inscription.

When printing normal plates with the inscription. remove bottom layer.
The tile will be strong. And the inscription against the light will be visible.
You will save time, material and energy.

PRINTING
layer height 0.2 mm
filling density 20%
filling pattern, lines
no supports

the cura program

Regards
LeFan