Pumpkin

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.3mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 This print uses 4 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Red At layer #13 (1.12mm) swap to Orange At layer #21 (1.76mm) swap to Yellow for the rest.