Thingiverse
Pumpkin Teeth Screw
door kirgy
10
Downloads
8
Likes
0
Makes
A screw that fits Dr_Ice's "Realistic Pumpkin Teeth", when the teeth are scaled to 200%.
If you need the screw to fit 100% scale, the screw thread is probably going to be too small - scaling up shouldn't be an issue.
### Instructions
Add a dot of glue into the tooth, then insert the screw thread side out. This has been designed so that the fit is fairly tight, but enough to allow the glue in/around the insert.
Infill: 5%
If you need the screw to fit 100% scale, the screw thread is probably going to be too small - scaling up shouldn't be an issue.
### Instructions
Add a dot of glue into the tooth, then insert the screw thread side out. This has been designed so that the fit is fairly tight, but enough to allow the glue in/around the insert.
Infill: 5%
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
