Thingiverse
Purge Tester
par shadowbert
1
Téléchargements
1
Likes
0
Makes
This was a designed as a quick test to work out the exact purge amount required to switch between colours in my A10M.
Printing:
Make sure your first layer is set to .3mm, and later layers to .2mm. Then it will match the model exactly.
Warning: Be a little gentle on heatbed settings. If you use a hot bed, it'll be difficult to remove this print from it.
Printing:
Make sure your first layer is set to .3mm, and later layers to .2mm. Then it will match the model exactly.
Warning: Be a little gentle on heatbed settings. If you use a hot bed, it'll be difficult to remove this print from it.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !