Thingiverse
Push pin clip
von Pa39
136
Downloads
142
Likes
0
Makes
Here is a push pin / clip i designed to replace a broken one on my motorbike.
this fits for a ~6mm hole.
I suggest printing it in PETG or ABS, as it should be too breakable in PLA.
this fits for a ~6mm hole.
I suggest printing it in PETG or ABS, as it should be too breakable in PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
