Push/Pull Handle and Lock for Door
by sccpsteve
0
Downloads
0
Likes
0
Makes
## Introduction
https://www.youtube.com/watch?v=sbRHNEvoEcc
I cheapened out on a new door lever that matched the old one which would cost $50 at the hardware store. Came up with this design to get the door to function again. It has a handle too. This was specifically designed for the bathroom, hence the privacy lock. This is by no means a permanent fix, but it'll get the job done.
Intended for American doors only, with a distance from the door knob hole to the side of the door of 2 3/8 inches. The door must be 1 3/8 thick, the door knob hole must be two inches in diameter.
## Features
| Feature | Locking Ver 1 | Locking Ver 2 | Non-locking Ver 2
|------------------------------------|-----------|-----------|
| Emergency lock release | ❌ | ✅ |❌ |
| Locking | ✅ | ✅ |❌ |
| Sleek design for "PUSH" plate | ❌ | ✅ |✅ |
| Threaded "PUSH" plate
https://www.youtube.com/watch?v=sbRHNEvoEcc
I cheapened out on a new door lever that matched the old one which would cost $50 at the hardware store. Came up with this design to get the door to function again. It has a handle too. This was specifically designed for the bathroom, hence the privacy lock. This is by no means a permanent fix, but it'll get the job done.
Intended for American doors only, with a distance from the door knob hole to the side of the door of 2 3/8 inches. The door must be 1 3/8 thick, the door knob hole must be two inches in diameter.
## Features
| Feature | Locking Ver 1 | Locking Ver 2 | Non-locking Ver 2
|------------------------------------|-----------|-----------|
| Emergency lock release | ❌ | ✅ |❌ |
| Locking | ✅ | ✅ |❌ |
| Sleek design for "PUSH" plate | ❌ | ✅ |✅ |
| Threaded "PUSH" plate
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!