Slicer Discord
Push-Push Mechanism Prototyper – 3D-Druckmodell von MakerWorld MakerWorld
Other Tools

Push-Push Mechanism Prototyper

403 Downloads
318 Likes
128 Makes
Zum Modell
A little prototyper I designed to test variations of the push-push mechanism, that funnily enough also holds up as a little fidget gadget. I aim to implement this mechanism into a future project (Now released after thorough testing phase!) and wanted an environment to test the push path. Hence, the path itself can be extracted and a new one screwed in and tested. Several pieces are included which show some improvements over the original, e.g. slopes allowing the mechanism to be used at angles. Required additional parts:a 5.5x39 mm springat least 1 M3x8 screw for the path1 M3x6 screw for the actuatorThe assembly quite straight forward. First insert the push path and screw it in from the back. Then insert the spring and the push plate, making sure the spring is within its designated hole. The more difficult part is to insert the actuator screw, while the mechanism is under tension (see picture 6). Therefore it is advisable to first thread the hole by screwing the M3x6 screw into the hole
Kategorie
Other Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen