Thingiverse
Pushup handle bar
door Anonaab
16
Downloads
15
Likes
0
Makes
Printable as a single part. Can be printed entirely without supports if your printer is amazing at bridging a 10 cm bridge. There is a hole on the bottom if you want to use supports for the handle.
I almost printed this but decided not to because its cheaper and faster to just buy them at a supermarket. But it is done so I give you my design here anyway.
I almost printed this but decided not to because its cheaper and faster to just buy them at a supermarket. But it is done so I give you my design here anyway.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
