Thingiverse
Puzzle Box Adjustable Holder
von MitsuEvoX12
5
Downloads
2
Likes
0
Makes
Made this adjustable puzzle stand for my wife.
Need 2x 3mx10 screws and nuts
I used PLA with 20% infill at .2mm layer height.
I did use a few supports on the clip portion to support the upper mount when printing on its side.
Need 2x 3mx10 screws and nuts
I used PLA with 20% infill at .2mm layer height.
I did use a few supports on the clip portion to support the upper mount when printing on its side.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
