Thingiverse

Puzzle Cube Twisty

by 8orge

14 Downloads

8 Likes

0 Makes

This is a twisty cube puzzle 3x3x3 and the final size is
30x30x30mm it is tiny .

If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :

I have based it upon the original model witch have all the cubes
attached with a string/rubber-band ,but i decided to make the
entire cube printable with pegs instead and now it is a
print and play model .
If you find it very hard to assemble you can find very good
illustrations on the net about how to solve it .
I did not have any problems at all getting all the tiny cubes to
rotate after the printing ,and because i have chamfered all
the edges ,they will not get stuck to each-other.
First layer i did set to 0.24mm ,but that depends on how your printer
is set up , the rest of the layers is 0.2mm .
It is printed in golden pla at around 215-220 degrees and 70 degree
hot-bed

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format