Thingiverse
PVC Blanket Clip
door MrSim1717
23
Downloads
15
Likes
0
Makes
This is a clip for 1/2 PVC pipe. I made this so that I can create blanket forts with my son. I modeled this clip based on the model found here:
https://www.thingiverse.com/thing:609205
I was concerned about my toddler choking on the smaller clip with this set. So I created a little bit larger version. I have included the Fusion 360 file for this so that it can be modified easier.
Disclaimer: I have no actual information on the safety of this part for toddlers. It may or may not be any safer than any other part.
https://www.thingiverse.com/thing:609205
I was concerned about my toddler choking on the smaller clip with this set. So I created a little bit larger version. I have included the Fusion 360 file for this so that it can be modified easier.
Disclaimer: I have no actual information on the safety of this part for toddlers. It may or may not be any safer than any other part.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
