Thingiverse
PVZ 2 Raise the Flag
door Jessica_
20
Downloads
13
Likes
0
Makes
So I am currently making different scenes from Plants vs zombies 2. This is the Flag of Power that is located in the center of the Backyard Battleground. This is where the most epic battles between plants and zombies take place and a neutral zone for both teams.
In this set you have the Flag pole with two flags ( one zombie flag and one plants flag). The flags should easily clip onto the flag pole. The zombie flag has a zombie face with the words "Zombies Drool" written on it, and the plants flag has a sunflower face with the words "Plants Rule" written on it.
***I have not printed this yet therefore some adjustments may need to happen in order to print right ***
***UPDATE...I printed the pieces last night. I would suggest printing with an infill of 50% or higher. I printed at 80mm/s with a 20% infill and the pole part of the flagpole did warp and twist. So I will be printing another one at 50 % infill and slowing the speed down to 65 mm/s and see if that helps for a better m
In this set you have the Flag pole with two flags ( one zombie flag and one plants flag). The flags should easily clip onto the flag pole. The zombie flag has a zombie face with the words "Zombies Drool" written on it, and the plants flag has a sunflower face with the words "Plants Rule" written on it.
***I have not printed this yet therefore some adjustments may need to happen in order to print right ***
***UPDATE...I printed the pieces last night. I would suggest printing with an infill of 50% or higher. I printed at 80mm/s with a 20% infill and the pole part of the flagpole did warp and twist. So I will be printing another one at 50 % infill and slowing the speed down to 65 mm/s and see if that helps for a better m
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
