PXMalion T320 Mods

This project is to provide modifications to the PXMalion T320 to make it easier to use and increase stability.

To Do: Add Photos of implementation and add more detail to hardware required.

Parts:
Extruder Boxes:
These move the extruder motors from the base of the printer to the top plate and use the existing mounting holes to hold the motor. This will allow your bowden tubes to hand down and not interfere with prints or have the potential to get snagged.

T320 Endstop:
This part uses a screw, nut and spring and then snaps onto the rod above the z endstop switch. This allows for manual adjustment of your z axis with a screw.

X Carriage:
This replaces the x axis carriage that houses the hotend assembly and uses LM8UU bearings to move away from using the stock bushings. This allows for smoother travel on the x axis.

Spool holders:
These allow you to install skateboard bearings and dowel rods to hold filament on the base of the printer instead of taking up more real