Thingiverse
Pythagorean Cup
door Richhe01
6
Downloads
3
Likes
0
Makes
Hello!
This is a modified Pythagorean's cup. There is no tower in the middle of the cup to house the siphon tubes! The model is 120 mm tall and 98 mm at its widest point. PLA was used for this print.
Recommended print settings:
.1 mm layer height
2 walls
Around 40-50 mm/s print speed
NO supports
Around 10% infill is recommended
Raft was used (no heated bed)
Assembly:
Slight sanding to smooth the surface as desired.
This is a modified Pythagorean's cup. There is no tower in the middle of the cup to house the siphon tubes! The model is 120 mm tall and 98 mm at its widest point. PLA was used for this print.
Recommended print settings:
.1 mm layer height
2 walls
Around 40-50 mm/s print speed
NO supports
Around 10% infill is recommended
Raft was used (no heated bed)
Assembly:
Slight sanding to smooth the surface as desired.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!