Thingiverse
pythagorus mug
von jude_the_dude
17
Downloads
13
Likes
0
Makes
A remix of the pythagorean cup by pythagorus. is functional albeit a bit slow.
when printing with supports you have to make sure that it doesnt generate supports inside the handle. this will block the flow of the water coming out. to do this in cura you have to use the support blocker. this will generate a cube that cura will not generate any supports in. just place a couple in the handle and your good.
when printing with supports you have to make sure that it doesnt generate supports inside the handle. this will block the flow of the water coming out. to do this in cura you have to use the support blocker. this will generate a cube that cura will not generate any supports in. just place a couple in the handle and your good.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
