Python AMS Enclosure Lid with overlap & flange

Updated 10th March 2025a few minor changes. a small lip added around each part where they join, this makes them a little more airtight (maybe), and also hold them together better, i also found that the 4 screws holding the handle were good enough to hold it all together without the need to use the screws between each part. your success with that will depends on filament shrinkage though.during assembly note the lips as they won't join together if your trying to do it wrong, join 2 together ,then the other 2 , then join the 2 sets of 2, hope that makes sense. eg join part 1&2, and 3&4, then then those 2 together. Python AMS Enclosure Lid with overlap & flangeDesigned in Fusion. i found the lid on the enclosure on my Python AMS was not flush fitting and was allowing to much air movement for the desiccant.also, i had cut my own clear plastic for the windows and cutting DIY with the curves was too much of a challenge.so i redesigned the lid with an overlap on the top and a inner ledge