QCXmini stand

I have been using the high quality settings and slowing the first layer down to 15mm/sec. This helps the first layer from getting pulled around. There is a round over on the bed side and it will hide any slight elephant foot you make so a raft is not needed.

Two are needed for the mini. It does not require unplugging anything to install or remove. It will hold the mini in three positions. a low angle for use on a tabletop, a high angle for use while sitting and upright for shelf use.

There are three small hooks that you can use to hang over an edge to keep from sliding during a button push. One for each position.