Thingiverse
QDX_box
von rr72
3
Downloads
2
Likes
0
Makes
Basic box for QRPLabs QDX transceiver.
The print works best with support enabled, but will work either way.
With support enabled, the board support may need to be cleaned up a bit. Board should slide in cleanly.
The face slips over the connectors and is secured by the top.
The lid is secured with M2.3*5 self tapping screws. The holes in the box and lid will likely need to be drilled out a bit to accommodate the screws.
The print works best with support enabled, but will work either way.
With support enabled, the board support may need to be cleaned up a bit. Board should slide in cleanly.
The face slips over the connectors and is secured by the top.
The lid is secured with M2.3*5 self tapping screws. The holes in the box and lid will likely need to be drilled out a bit to accommodate the screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
