Thingiverse
Qidi Max4 Second Camera for D3P Riser
door opjose
0
Downloads
0
Likes
0
Makes
This print permits you to mount a second inexpensive wide angle camera into the D3P riser for the Qidi Max4.
(See: https://cults3d.com/en/3d-model/tool/d3p-riser-for-qidi-max-4 )
The mount is printed in two parts that are glued together after printing and installing the inserts.
The base replaces one of the clips used to assemble the riser's frame.
The camera case stand is affixed to the mount using M3 screws threaded into M3x6x5 heat inserts.
The base is held in place against the weight of the camera, by looping the USB cable under the riser top and/or affixing the cable loops with a wire tie.
(See: https://cults3d.com/en/3d-model/tool/d3p-riser-for-qidi-max-4 )
The mount is printed in two parts that are glued together after printing and installing the inserts.
The base replaces one of the clips used to assemble the riser's frame.
The camera case stand is affixed to the mount using M3 screws threaded into M3x6x5 heat inserts.
The base is held in place against the weight of the camera, by looping the USB cable under the riser top and/or affixing the cable loops with a wire tie.
opjose publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!