Thingiverse
QIDI Q2 Back Spool Bar
by Po_temkin
3
Downloads
4
Likes
0
Makes
Have a nice day everyone!
Recently I got my QIDI Q2 and found that the stock spool holder is perfectly useless.
Moreover, I didn't find good bars that can support wide spools.
So, I made a new one.
The maximum supported spool width is about 110 mm.
Print it on its top to avoid using supports.
Set 5 perimeters and 10 shells (or more) to make it robust.
Recently I got my QIDI Q2 and found that the stock spool holder is perfectly useless.
Moreover, I didn't find good bars that can support wide spools.
So, I made a new one.
The maximum supported spool width is about 110 mm.
Print it on its top to avoid using supports.
Set 5 perimeters and 10 shells (or more) to make it robust.
Po_temkin also publishes on
21 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
