Slicer Discord
Qidi X-Max Waveshare Display Adapter – 3D-Druckmodell von Thingiverse Thingiverse

Qidi X-Max Waveshare Display Adapter

von ecsv
8 Downloads
7 Likes
0 Makes
Zum Modell
If you want to switch your Qidi X-Max (1) from the (slightly frustrating) original firmware to Klipper, then the original touchscreen cannot be used anymore. But it is possible to use other touchscreens on your the RaspberryPI (which runs Klipper(screen)). [Waveshare has a 5 inch touchscreen](https://www.waveshare.com/5inch-dsi-lcd.htm) with a board which is smaller in width and height. It is therefore ideal to be used together with a self-designed adapter.

Additional materials required:

* 1m or 1.5m (depending on the position of your RPi) DSI/CSI 15 pin flat flex cable (please ping me if you find one with good EMI shielding)
* 8x short M2.5 screws to attach the display to the adapter (should hopefully be delivered with the display)
* use original screws to attach the adapter to the Qidi X-Max chamber


My display (or the Qidi display mounting points) was tilded for me by 0.23 degree. I've compensated this by misaligning the outer holes by 0.25mm. If you want to change
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

ecsv veröffentlicht auch auf

19 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

3 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen