Qidi X-Plus 3 Flat Front Panel Kit

This kit is for mounting a polycarbonate sheet in place of the original front panel. This allows for clear viewing of the first few layers while the door is closed. To use this kit you will need:412x305mm Polycarbonate sheet (3mm thick)4 x M5x16mm countersunk screws5mm drill bit (for the polycarbonate)2 x 10x3mm magnets (if you wish to use the magnetic closing on the doorPrior to drilling holes in the polycarbonate make sure the edge pieces are aligned properly on your machine as the polycarbonate sheet does not need to go entirely into the slots.