Thingiverse
QIDI X-PLUS 3 TOP LID RISER
por KeiEich
14
Descargas
18
Likes
0
Makes
Lift the top lid 40mm.
I made this so that I could leave the top lid on while printing PLA.
Compared to completely removing the top cover, the internal temperature will rise by about 4 degrees Celsius. I recommend leaving the front door open.
0.2mm layer hight.
no support.
If printing does not work, flip it upside down and print with support.
I made this so that I could leave the top lid on while printing PLA.
Compared to completely removing the top cover, the internal temperature will rise by about 4 degrees Celsius. I recommend leaving the front door open.
0.2mm layer hight.
no support.
If printing does not work, flip it upside down and print with support.
KeiEich también publica en
16 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
