Qidi XPro Front Gap Plug

These two things solve the problem of tiny screws and filament pieces falling through the front gap between the Qidi Xpro build cavity front panel and floor. I don't like screws falling through there because the front panel circuit board is mounted right below the gap.

I found the rails were a bit tricky to print because of bed adhesion on the thin rails. So, be sure to use adhesion all the way to the edges of your build plate because the pieces are quite long.

I also put a strip of sticky kitchen drawer liner under the plastic pieces so that they would not slide around. They work fairly well.

I built them to stop extruder screws from falling in the gap, but have since learned that they stop filament bits frequently.