Thingiverse
QO-100 Poty protector
by PatriceB78
1
Downloads
1
Likes
0
Makes
I present you a QO-100 poty antenna protector.
You need to buy separately the "bubble" that will be in front of the antenna. You can find it at this place (at least in France):
https://www.cultura.com/boule-plastique-12cm-2-parties-3700408387402.html
Any cristal plastic half ball should be OK, diameter is 12cm.
No difficulty to print even with basical printer I guess.
My LNW was a Telefunken one. Octagon looks to fit also but I didn't check completely.
You need to buy separately the "bubble" that will be in front of the antenna. You can find it at this place (at least in France):
https://www.cultura.com/boule-plastique-12cm-2-parties-3700408387402.html
Any cristal plastic half ball should be OK, diameter is 12cm.
No difficulty to print even with basical printer I guess.
My LNW was a Telefunken one. Octagon looks to fit also but I didn't check completely.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
