Thingiverse
QU-BD Filament Guide
door pmm
34
Downloads
25
Likes
0
Makes
This guide is those with a filament spool on the side of the printer. I tried several of the other great guides for the QU-BD, but they didn't work for my setup, so I created this one to replace the binder clip I was using.
It attaches under one of the screws securing the top strut. Be sure to us a bit of fine sandpaper to smooth down the inside of the ring and around the ring edges.
The Inventor file is included should you want to make changes.
It attaches under one of the screws securing the top strut. Be sure to us a bit of fine sandpaper to smooth down the inside of the ring and around the ring edges.
The Inventor file is included should you want to make changes.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
