Thingiverse
Quad/Drone Wall Mount
por eried
22
Descargas
23
Likes
1
Makes
The main design is based on the source, however there are few changes, specially:
* Thinner in general. More than 1.5 mm is overkill for drones that weight less than a kilo.
* Hole for a small nail/tack (I think only double sided tape is not safe enough vs a mechanical link)
* Thinner in general. More than 1.5 mm is overkill for drones that weight less than a kilo.
* Hole for a small nail/tack (I think only double sided tape is not safe enough vs a mechanical link)
eried también publica en
130 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
