Quadcopter Antenna Bracket

When I put together my first drone I had followed the advice of many, online, to mount my receiver antennas to the frame's standoffs. However, not only did this leave them too close to the props for comfort, but it only separated them by only ~20 degrees.

Therefore i quickly threw together these mounts.

By printing two (for a diversity receiver) and zip-tying them under your frame, on either side, they should hold the antennas at a right angle to one another.

Note: The side with the depression is where you put the antenna and should be facing out from the center of your quad. Once zip-tied into the mount, the antenna should be held at a 45 degree angle.

I also included the 123D Design file, so feel free to edit it to suit your needs.