QUADCOPTER BODY

First prototype of my Quad copter body.
It has 2 separate compartments, Lower for the Lipo battery, it should easy hold 2 3000mah's, with access holes at the front and the back for power cables
An upper section for all electronics including slotted holes for flight controller and power distribution board, slots for Velcro straps to hold battery firmly in place
Measuring 475mm diagonally and fitting 28x25mm motors.
Arms and body are held together with M3 nuts and bolts, so no need for gluing.
( Found out for certain on Thursday night that gluing a 3d printed quad together is not the best idea, sod the weight! )
This should print perfectly, going to start printing it now, so will make changes if needed.
The lids for the 2 compartments i will do later today or this week.
I'll definitely be making a newer design when i have the time, trim a lot of the weight off and making it a lot sleeker looking.
Also have some feet to upload that attach directly to the motor mount bolts.