Slicer Discord
Quadcopter Launch Pad  – 3D-printbaar model van Thingiverse Thingiverse

Quadcopter Launch Pad

door eix0r
25 Downloads
17 Likes
2 Makes
Model downloaden
This is a redesign of a Launchpad I found on Thingiverse, (https://www.thingiverse.com/thing:2393056) the original had the issue that the arms would slide down over time, so I added some knobs to prevent this. Downside is you can only change the angle in 15° Steps.

You will need 2x M4 screws + 2x winged nuts for the arms and one M3 screw to combine the two foots. The screw should turn freely in the foot, but should be fixed in the arm.

Since the knobs are really small, I recommend printing with 0.1mm Layerheight and a small nozzle (I used Standard 0.4mm) to get them right. Generelly you will need a well tuned printer. If you have Issues you can try printing at 150% Scale (bigger screws needed than)
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
0.10mm lagen
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 2/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Laaghoogte
0.1 mm
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie