Thingiverse
Quadrazquina
door jaln
42
Downloads
34
Likes
1
Makes
An older design I never uploaded. I have several and will continue to upload some more.
This design is intended for corkscrew, single wall printing.
I used PLA+ and PETg. .2mm layers. Use 5 or 6 bottom layers, zero top layers.
Use ballast for stability; marbles, small river rock.
You can also use 2 walls thick. 5 or 6 bottom layers, no top layers, no fill, for a sturdier and more water tight piece.
This design is intended for corkscrew, single wall printing.
I used PLA+ and PETg. .2mm layers. Use 5 or 6 bottom layers, zero top layers.
Use ballast for stability; marbles, small river rock.
You can also use 2 walls thick. 5 or 6 bottom layers, no top layers, no fill, for a sturdier and more water tight piece.
jaln publiceert ook op
81 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
