Thingiverse
Quadro Duplo Adapter
par jaschispatz
1
Téléchargements
2
Likes
0
Makes
This part enables you to build with Lego® Duplo on your QUADRO Climbing frame.
To complete the build you will need:
- 4 M3 cylinder head screws with a shaft length of 20mm
- 4 M3 washers (I used polymer ones)
- 1 piece of sponge rubber 34mm x 96mm which is 1.5mm thick
- 2 pieces of velcro which are 250mm long and have a width of 10mm
- 1 Lego Duplo tile which is 2 by 6 studs large
Instead of printing the studs, a piece of Duplo was used to get the perfect fit with any connected Duplo.
To complete the build you will need:
- 4 M3 cylinder head screws with a shaft length of 20mm
- 4 M3 washers (I used polymer ones)
- 1 piece of sponge rubber 34mm x 96mm which is 1.5mm thick
- 2 pieces of velcro which are 250mm long and have a width of 10mm
- 1 Lego Duplo tile which is 2 by 6 studs large
Instead of printing the studs, a piece of Duplo was used to get the perfect fit with any connected Duplo.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
