Quail Rails

Quail rails I've been tinkering around with. It was made for the Little Giant incubator and when assembled it has a capacity of 23 eggs per rail.

Since there is a bit of assembly required I printed mine in ABS. That was simply so I could acetone weld it together. I'm sure any other plastic and superglue would also work.

### Problems ###
These are still a work in progress, comments are most certainly welcome.

1. The cups are too deep and cannot be place next to each other.
1. I would like to redesign the cup so that the bottom collar isn't needed.
1. Tweak the arms that slot into the incubator to remove post processing


### Revisions Made ###
1. Removed the bottom of the cups. Some eggs where hard to get out of the cups, which was annoying when transferring them to lock down. Removing the bottom should make this process easier.