Quest 2 Elite strap quick fix

This fix prints a quick bracket to support the damaged area of the Oculus 2 elite strap.

Install instruction:
- Print
- Snap the "lid" of the "bracket"
- Place "bracket" around strap.
- Close the lid (make sure it is a tight fit).

NB! This is a tight fit! But depending on the shrinkage and printer setup it might not fit because of the small tolerances.

A tip from me is to print it out 0.5cm for a test run to see if it fits your device. Then print the entire 3.5cm when it fits. Add tape or something underneath to tighten it up if needed.