Quest 2 Touch Controller trigger

This is a replacement trigger and trigger stop for a Quest 2 trigger (STL files are models for the right controller trigger and stop-- for the left controller mirror them on one axis in your printing software).

These are cleaned up from 3D scans of the parts. I'm a bit surprised they scanned and printed as well as they did. The parts fit fine directly out of my printer (some support material shaving and cleanup, but not much). Depending on your printer and material, the holes for the screws and pivot may need a bit loosening (just turn the point of some sharp tweezers to reem out a bit, or use a tiny drill bit if really necessary).

BE GENTLE AND CAREFUL when opening the controller. The tiny ribbon cable connector connecting the handle part to the main board is delicate. Take note of the trigger assembly-- connecting the stop is pretty straightforward (a single screw). The axle is a bit more complicated. Make sure you note the orientation and the spring placement on the axle/pi